So, I was wondering...
What are the most common thread sizing and spacing for screw holes for pocket clips on custom made lights? Is there a common denominator on these?
Asking for a friend.
Hogo- I can send you a McGizmo clip and screws if you'd like, to play around with. Let me know. It fits my Okluma, and the clip screw spacing was the same on the Hanko I owned. Steel Flame fit all the above-mentioned lights too, so I think the spacing is pretty standardized.
Edit- I can send pics to you with micrometer measurements also, either way...
Does anyone remember the previous post about the custom clip project and the holes in the tail section just under the tailcap?
That is a clip from a Jetbeam, and it uses the same screw spacing as a McGizmo.
Henry often says no no no no, before he says, maybe maybe maybe, then he says yes (sometimes).
i just looked at my rotary. So this clip option will shorten the amount of travel on the rotary mechanism due to it hitting the clip right? Did you install it on the high beam or low beam side of henry’s screw stop?
im a clip guy... i wear dress slacks all day w shirt and tie and the current frankenclip for the rotary doesnt hold taught. I have to keep taking it off and bending it tight. Almost went back to my clicky.... almost... lol