mohavewolfpup
Newly Enlightened
- Joined
- Jan 16, 2008
- Messages
- 10
I own some Inova t4's, the rechargable kind. these don't have the stainless steel rings at the front, just black all around.
i followed everything as best as I could on here about cleaning them throughly, and still get issues with the chargers blinking the leds blue.
have I overlooked anything? did I clean them improperly? taking the charger unit apart i'm wondering if the springs are too weak or something and contact is not fully being made between the circuit board and the pins that interface with the 2 brass screws on the flashlight. I did get a full charge out of it with no blinking ever, but twice so far they started blinking again during the charging cycle, then has done it twice so far in the same charging cycle.
the springs looked bent slightly when i pulled the cover off, could that possibly be a problem?
i tried searching for more info after joining as a member, but get errors about memory not being allocated for that operation.
i followed everything as best as I could on here about cleaning them throughly, and still get issues with the chargers blinking the leds blue.
have I overlooked anything? did I clean them improperly? taking the charger unit apart i'm wondering if the springs are too weak or something and contact is not fully being made between the circuit board and the pins that interface with the 2 brass screws on the flashlight. I did get a full charge out of it with no blinking ever, but twice so far they started blinking again during the charging cycle, then has done it twice so far in the same charging cycle.
the springs looked bent slightly when i pulled the cover off, could that possibly be a problem?
i tried searching for more info after joining as a member, but get errors about memory not being allocated for that operation.