Is it possible to make a Nitecore EZ series Clip on the camera mount?

[dracodoc]

Just thought about this. If somebody or Nitecore can make a clip which will have a screw to use the camera mount hole in EZ AA/123/CR2, this clip will be secure, easily removable(you may need to put a paper between clip and body when installing/removing it to avoid scratches) .

What do you think?

 

[dracodoc]

OK, just found this has been mentioned in another thread. I tried to search that thread before posting because I knew there was that thread, but didn't find it.

 

[Dan FO]

What would keep the clip from spinning?

 

[dracodoc]

Hmm, nothing except the friction. So if it was tighten enough and there is not much force to spin it, it could be OK. I don't know how will it work in real life.
There are many clips are just clipped on light, I think they also can be turned, thus scratch the light body?