I just received some of these from Kaidomain and as a total newbie building his first light would like to check on something. The board has a couple of very small holes going through to the +ve and -ve battery contacts.
Are these meant for wiring from the component side and is this considered a good idea or doesn't it make any difference one way or the other?
Incidentally the boards look slightly different to those shown in some of the threads on here. The R2 resistor is labelled R27 not R220. Presumably this will lower the output current slightly?
Regards,
bogster
Are these meant for wiring from the component side and is this considered a good idea or doesn't it make any difference one way or the other?
Incidentally the boards look slightly different to those shown in some of the threads on here. The R2 resistor is labelled R27 not R220. Presumably this will lower the output current slightly?
Regards,
bogster
