Need SOB info on +/- wires to LED

[dirtech]

The Sandwich Shoppe has been down for over 24hrs and I'm dead in the water without knowing where to connect the pos led and neg led wires.

Any help?

I contacted Dat2zip but I think he's too busy to get me the info or the site is having serious issues. Perhaps he's busy trying to fix it.

 

[dirtech]

Nevermind! Reading is fundamental. It says it right on the bat side.

 

[darkzero]

Sounds like you got it already but just in case here's a pic I posted a while ago.

 

[dirtech]

Thank you darkzero. Save to the desktop.

 

[Justin Case]

Note that either hole labeled LED+ can be used for that purpose. Same for LED-. Also, Batt+ is the same as the center anode pad on the non-component side of the board. Batt- is the same as the outer ground ring on the non-component side of the board.

 

[dirtech]

Thank you Justin Case. I take that the two holes for each pos and neg led will drive two LED's at 1000ma or would the current be split?

 

[Justin Case]

If you connect two identical LEDs in parallel, then effectively a parallel resistor divider applies. The current will be split 50-50.

The typical use for those holes I've seen is to build parallel-wired sandwiches of multiple SOBs to get more drive current. For example, a 3xSOB1000 -> SOB3000. See this for example.