Pentagon L2 upgrades or improvements?

[FlyPenFly]

Just wondering, are there any good LED upgrades or other improvements I can make to the light?

 

[FlyPenFly]

Bumping this with my hopes and dreams.

 

[spoonrobot]

There aren't any aftermarket parts that are made for the L2.

However, if you are so inclined to break the adhesive holding the bezel shut you can open the head, remove the stock lamp assembly and add a P60-sized drop-in.

The drop-in will rattle since the P60 reflector size is 26mm and the Pentagonlight size is 27mm, but it will function fine because the lengths are the same.

 

[FlyPenFly]

There aren't any aftermarket parts that are made for the L2.

However, if you are so inclined to break the adhesive holding the bezel shut you can open the head, remove the stock lamp assembly and add a P60-sized drop-in.

The drop-in will rattle since the P60 reflector size is 26mm and the Pentagonlight size is 27mm, but it will function fine because the lengths are the same.

What if you put some electical tape around the reflector? I think that might tighten it up?

 

[greenstuffs]

What if you put some electical tape around the reflector? I think that might tighten it up?

If the drop in runs hot it may overheat since it has no contact to the bezel for heat disipation.

 

[spoonrobot]

I used an index card cut to shape and wrapped around the lamp assembly when I ran a P90 in my X2 head, but I assume that would insulate the LED engine too much. Maybe some kind of thin sheet metal or something else that would transfer the heat better?

 

[FlyPenFly]

Aluminum foil?