• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired Sell:custom Quad XP-G P60 module 3rd Run *open*

kerberos0023

Enlightened
Joined
Mar 1, 2010
Messages
397
Location
Tokyo Japan
:welcome: I sell this!



The 3rd run will be limited to Direct Drive 4200mA 3-mode XP-G R5 only! The sale number is ten in all.



The module sends it out from the middle of January, 2011.



I begin to sell it for $160(Direct Drive) $180(4200mA 3-mode) including the EMS postage!



The GITD processing is plus $10.



This becomes very hot.

The use battery is with 3.7V Li-Io battery protection circuit.

If a light becomes hot, please cut the light which is in a dangerous state.

Please be careful to the handling.

After understanding, please refer as things mentioned above.



?This light creates excessive heat :caution:

?The consecutive lighting is dangerous. :caution:

?If a light is overheated, please turn off the light.:caution:

?This light may cause eye damage :caution:

?This light will burn the skin at close range. :caution:

?This light may cause combustibles to ignite :caution:

?This drop-in is a direct drive unit. :caution:

?IMR cells are not recommended. :caution:



When you used the large-capacity battery except 17670 and 18650 of the battery with the protection circuit, the possibility that an excessive electric current flows, and LED is broken is very high.

Because I sell 4200mA converter in 2nd Run if you use a large-capacity battery except 17670 and 18650, please wait till then.

Please use only 17670 or 18650.

It is very likely that LED is broken! :caution:





:thumbsup:

I sell this custom Quad XP-G P60 module.

I begin to sell it for $160(DD) $180(4200mA 3-mode) including the EMS postage!

This light creates excessive heat.

Please use 18650 or 17670 expensive battery of the electric discharge performance.

The payment is PeyPal.

Post your order here and I will PM you the total along with my PayPal address.





Cutter-XPG25RDR5-CW (remodeling board 20mm)

p10102820.jpg




Carclo 24mm Quad Optics

carclo24mmquadoptics.jpg






Quad XP-G DD Module



Quad XP-G Module 4200mA 3-mode

*3 modes: Low-Med-High

* Voltage input: 2.8V - 5.5V

* The memory feature will memorize the last mode

sany3879.jpg
sany3822.jpg
sany3826.jpg




surefire 6P C2 normal body

sany3809.jpg




sany3807.jpg
sany3805.jpg




sany3815.jpg
sany3810.jpg
 
:welcome: I sell this!



The 3rd run will be limited to Direct Drive 4200mA 3-mode XP-G R5 only! The sale number is ten in all.



The module sends it out from the middle of January, 2011.



I begin to sell it for $160(Direct Drive) $180(4200mA 3-mode) including the EMS postage!



The GITD processing is plus $10.



This becomes very hot.

The use battery is with 3.7V Li-Io battery protection circuit.

If a light becomes hot, please cut the light which is in a dangerous state.

Please be careful to the handling.

After understanding, please refer as things mentioned above.



?This light creates excessive heat :caution:

?The consecutive lighting is dangerous. :caution:

?If a light is overheated, please turn off the light.:caution:

?This light may cause eye damage :caution:

?This light will burn the skin at close range. :caution:

?This light may cause combustibles to ignite :caution:

?This drop-in is a direct drive unit. :caution:

?IMR cells are not recommended. :caution:



When you used the large-capacity battery except 17670 and 18650 of the battery with the protection circuit, the possibility that an excessive electric current flows, and LED is broken is very high.

Because I sell 4200mA converter in 2nd Run if you use a large-capacity battery except 17670 and 18650, please wait till then.

Please use only 17670 or 18650.

It is very likely that LED is broken! :caution:





:thumbsup:

I sell this custom Quad XP-G P60 module.

I begin to sell it for $160(DD) $180(4200mA 3-mode) including the EMS postage!

This light creates excessive heat.

Please use 18650 or 17670 expensive battery of the electric discharge performance.

The payment is PeyPal.

Post your order here and I will PM you the total along with my PayPal address.





Cutter-XPG25RDR5-CW (remodeling board 20mm)

p10102820.jpg




Carclo 24mm Quad Optics

carclo24mmquadoptics.jpg






Quad XP-G DD Module



Quad XP-G Module 4200mA 3-mode

*3 modes: Low-Med-High

* Voltage input: 2.8V - 5.5V

* The memory feature will memorize the last mode

sany3879.jpg
sany3822.jpg
sany3826.jpg




surefire 6P C2 normal body

sany3809.jpg




sany3807.jpg
sany3805.jpg




sany3815.jpg
sany3810.jpg
 
Keshi,

I found your "open" thread selling the triple XP-G for the Solarforce L2P. However while I found it doing a search I the site does not allow for threads that have been added to. So I decided to try to contact you using this thread in hopes that I can purchase the module drop in that I want.
So, if the administrators allow my first post to go through in the thread that I found doing a search you may see this same request from me. The part I want to buy is listed here below. I don't know if the part includes heat sink and Carcla lens. I wish to buy the part in any event. My email is [email protected] Please contact me there. I can make Paypal payment if you can sell me the part. Also feel free to let me know if the cost is higher now.
Thank you
Jim


4) tliple XP-G R5 3-mode 2800mA $135 Mat black 😀 G.I.T.D 😀 A part of the PCB In stock : 1
 
Back
Top