nbjly
Enlightened
- Joined
- Dec 12, 2004
- Messages
- 393
SOLD This light has done nightstand duty, it has a few marks, no dents or dings - 99.9% It is amazing at night. There are trits under side of clip, so that if you don't use the clip, the symmetry is maintained - no missing trits. The switch has been reshaped and the slots cut all the way through to give the classic 3D tail. One trit on the extender is out. The extender is bored so it can use 17500 batteries. Will operate at *very* low output. It is on the left in the daylight pictures, it is the red one in the dark pictures. None of the other lights are available.
Consider trade +/- for JHanko D10's (not blue or green)
$799 SOLD $750 Shipped USPS Priority to USA addresses
It has the following mods:
3D Tail
Slotted bezel
Cut down body
Clip & screws installed
Drill out heat sink
Cut down hex, bore & slot AA extender
46 Red tritium vials installed
Install Nichia 219 LED
3 trits in tail switch - (I have an empty 6 trit switch for sale)
12 trits at tail
10 trits at middle
8 trits on extension
8 trits in fins
5 trits in bezel
46 trits total
20mb image hosting
Consider trade +/- for JHanko D10's (not blue or green)
$799 SOLD $750 Shipped USPS Priority to USA addresses
It has the following mods:
3D Tail
Slotted bezel
Cut down body
Clip & screws installed
Drill out heat sink
Cut down hex, bore & slot AA extender
46 Red tritium vials installed
Install Nichia 219 LED
3 trits in tail switch - (I have an empty 6 trit switch for sale)
12 trits at tail
10 trits at middle
8 trits on extension
8 trits in fins
5 trits in bezel
46 trits total
20mb image hosting
Last edited:
