I love super charger, have one on my car
The Light for sale is a mag 2D SST-50, Super Charged to 7Amp.
Sleeper mod, Two modes: Dark Silence & OMG I am Blind!
The driver is the last one of this from DIWdriver, specially made for me for 7AMP drive current.
http://www.candlepowerforums.com/vb/showthread.php?t=264687
The Battery are theses 4000mAH 4x 1/2 D cells:
Not available in the US yet, only one seller out of UK has these cells:
http://cgi.ebay.com/4000mAh-1-2-D-N...0271904888?pt=UK_ToysGames_RadioControlled_JN
Why 1/2 D cells? Because It allows me to make a light that could out throw the SST-90 on Mag 2D I sold not long ago but with 2x capacity, i.e. 2x the run time. See the prior light here:
http://www.candlepowerforums.com/vb/showthread.php?t=278919
Specs:
The Light is Priced at $195 with the 4 batteries included
or $175 w/o the batteries. Keep in mind that if you take the 175 option, you'll need to get the 1/2 D cells your self from the link above & cut & grind away the tabs but leave one layer of tab on pos. end to make contact, can not use any other batteries!.
Ship in US preferred: two options:
PP gift/money owned Option will cost $12, includes shipping cost, insurance & delivery conf.
PP regular will cost $19, which includes the above & covers the 4% PP fee.
Ship international are offered at $24 S&H, there'll be no insurances or tracking # & buyer take the shipping/custom risk. Therefore, I only accept Gift/Money Owned option for international shipping. I will provide custom declaration #.
This is like shrinking a Vara2000 3D down to 2D.
Extremely Powerful, only more compact. This has never been done before,
a lot of work have been put into this light to over come many obstacles.
Posting of has priority over PM.
The mag switch with copper pos. & grind down bottom:
The Light for sale is a mag 2D SST-50, Super Charged to 7Amp.
Sleeper mod, Two modes: Dark Silence & OMG I am Blind!
The driver is the last one of this from DIWdriver, specially made for me for 7AMP drive current.
http://www.candlepowerforums.com/vb/showthread.php?t=264687
The Battery are theses 4000mAH 4x 1/2 D cells:
Not available in the US yet, only one seller out of UK has these cells:
http://cgi.ebay.com/4000mAh-1-2-D-N...0271904888?pt=UK_ToysGames_RadioControlled_JN
Why 1/2 D cells? Because It allows me to make a light that could out throw the SST-90 on Mag 2D I sold not long ago but with 2x capacity, i.e. 2x the run time. See the prior light here:
http://www.candlepowerforums.com/vb/showthread.php?t=278919
Specs:
- Black Mag2D as Host, Deep Rebel SMO as reflector
- Der Wichtel's new SST-50 heat sink made for Rebel SMO (17 Euro +6 Euro shipping to US, how many $$ is that?)
- The last one of the DIW high efficiency driver, special made for me @ 7 Amp.
- Copper disk heat sink for the special driver
- Mag Rebel Deep SMO reflector delivers intense & small round hot spot with ultimate throw
- 20AWD Silver coated copper wire in Teflon Sleeve
- Lead wires was potted through the heat sink holes by JB weld to minimize the possibilty of solder joint failure
- Extreme Top Bin SST-50 57K, GJ Bin (I only use Top bin)
- mag D switch resistance Mod
- mag D switch size reduction mod (The bottom of the D switch was grind down by a few mm, contact replaced with copper plate. The grinding is necessary to fit the 4x 1/2 D cells.)
- 4x 1/2 D 4000 mAH NIMN delivers 7AMp through the driver,
- >1,500 lumens (the J bin spec at 5A is >1250 lumens) at LED with Run Time 2x as long as the last one I made
- Bored Tail Cap to accepts the 1/2 D cell into the tail with Recessed spring mod
- Down load's Mag Ring II for D Mag (The only way to make the 4x 1/2 D fit) also add layard carry functionality.
- I am pretty sure this will blow away just about any Mag you may have
The Light is Priced at $195 with the 4 batteries included
or $175 w/o the batteries. Keep in mind that if you take the 175 option, you'll need to get the 1/2 D cells your self from the link above & cut & grind away the tabs but leave one layer of tab on pos. end to make contact, can not use any other batteries!.
Ship in US preferred: two options:
PP gift/money owned Option will cost $12, includes shipping cost, insurance & delivery conf.
PP regular will cost $19, which includes the above & covers the 4% PP fee.
Ship international are offered at $24 S&H, there'll be no insurances or tracking # & buyer take the shipping/custom risk. Therefore, I only accept Gift/Money Owned option for international shipping. I will provide custom declaration #.
This is like shrinking a Vara2000 3D down to 2D.
Extremely Powerful, only more compact. This has never been done before,
a lot of work have been put into this light to over come many obstacles.
Posting of has priority over PM.
The mag switch with copper pos. & grind down bottom:
Last edited: