Textured Carbon Fiber XM-18 scale
- Thread starter The Sun
- Start date
Help Support Candle Power Flashlight Forum
blitzlicht65
Enlightened
Great work!!!:thumbsup:
You must fill the holes in front of the scale with green glow-powder.:naughty:
:wave:
You must fill the holes in front of the scale with green glow-powder.:naughty:
:wave:
actually this one didn't get the glow treatment. this scale was made for a good friend of mine that carries his XM's tip-down. he wanted a little more texture by the pivot to aid in taking it out of his pocket.
if you scroll down a bit in the "knives" forum you'll see some XM-18 scales that i did put a 24hr. proprietary glow solution in though.
right here: http://www.candlepowerforums.com/vb/showthread.php?t=285548
thanks!
if you scroll down a bit in the "knives" forum you'll see some XM-18 scales that i did put a 24hr. proprietary glow solution in though.
right here: http://www.candlepowerforums.com/vb/showthread.php?t=285548
thanks!
houtex
Enlightened
That is some very beautiful work you are doing. I've been following alot of your post. All very,very nice. Keep it up.
Thank you!
I've been doing modifications for a long time. I primarily operate on another forum, but I thought i should get back to CPF and post some pics for you guys/gals!!!!
I've been so busy the last couple years I haven't been able to get over here very much!
Thanks again!!!
I've been doing modifications for a long time. I primarily operate on another forum, but I thought i should get back to CPF and post some pics for you guys/gals!!!!
I've been so busy the last couple years I haven't been able to get over here very much!
Thanks again!!!
