Hey all I'm putting this up again...
Ganp Deviant 27LT $290, shipped. Also includes 3 AW 17670 rechargeables. only a few cycles on each battery.
From this sales thread:http://www.candlepowerforums.com/vb/...t=ganp+deviant
The head is McLux 27LT fitting and houses an McR 27XR reflector, double AR coated UCL lens, interchangeable XR-E R2(WG)/GD1000 light engine, and a slim stainless steel bezel.
The body is fitted with a McClickie switch, and is drilled and tapped ready to fit a Titanium clip (not included). Shorter than normal screws are required to fit a clip and will be included in the sale, along with spare head and bezel o-rings.
Also included for future upgrades is another LE can, a heatsink ready sized for an XR-E Led mounted on a 14mm star, a blank heatsink, and some Delrin insulators. (The insulators are purely cosmetic in this build). The LE can is sized for 14.00mm diameter driver boards.
Head and body are made from 6082 alloy, finished in HA Nat' dark olive, and are a very good match. Of the lights I have made, I think this one has the best anodising so far and the surface is silky smooth with no burrs or rough edges.
The beam is nice and smooth. Runtime from a charged AW RCR17670 (protected) battery is estimated at approx' 45 minutes of constant bright light (depending on the state of the battery).
US sale only, on this one. Not responsible for package once its in the hands of the USPS. Ins. available at cost.
Ganp Deviant 27LT $290, shipped. Also includes 3 AW 17670 rechargeables. only a few cycles on each battery.
From this sales thread:http://www.candlepowerforums.com/vb/...t=ganp+deviant
The head is McLux 27LT fitting and houses an McR 27XR reflector, double AR coated UCL lens, interchangeable XR-E R2(WG)/GD1000 light engine, and a slim stainless steel bezel.
The body is fitted with a McClickie switch, and is drilled and tapped ready to fit a Titanium clip (not included). Shorter than normal screws are required to fit a clip and will be included in the sale, along with spare head and bezel o-rings.
Also included for future upgrades is another LE can, a heatsink ready sized for an XR-E Led mounted on a 14mm star, a blank heatsink, and some Delrin insulators. (The insulators are purely cosmetic in this build). The LE can is sized for 14.00mm diameter driver boards.
Head and body are made from 6082 alloy, finished in HA Nat' dark olive, and are a very good match. Of the lights I have made, I think this one has the best anodising so far and the surface is silky smooth with no burrs or rough edges.
The beam is nice and smooth. Runtime from a charged AW RCR17670 (protected) battery is estimated at approx' 45 minutes of constant bright light (depending on the state of the battery).
US sale only, on this one. Not responsible for package once its in the hands of the USPS. Ins. available at cost.
