-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
Sold/Expired wvaltakis Ti HDS clip & screws **SOLD**
- Thread starter F250XLT
- Start date
Help Support Candle Power Flashlight Forum
archimedes
Flashaholic
There are some differences in clip-hole spacing among the different Novatac/EDC/HDS/Ra lights ... if you might be able to check and confirm fitment for a "Legacy" HDS Clicky (such as the 170T), I'd definitely be interested.
Re: wvaltakis Ti HDS clip & screws
I have no way of knowing, I only own the original HDS lights.
I have no way of knowing, I only own the original HDS lights.
archimedes
Flashaholic
What's the approximate angle between attachment points?
In other words, if one of the screws is at "noon", where's the other? 🙂
In other words, if one of the screws is at "noon", where's the other? 🙂
archimedes
Flashaholic
Thanks, and good luck with sale ( I am looking for the type that is about 100 degrees, or at about "3:30" ) .... I think these earlier versions were approximately 90 degrees apart.
Re: wvaltakis Ti HDS clip & screws
It should fit most HDS lights up to but not including the most recent generation (which are not drilled for clips). Also it will NOT fit the Ti clicky. This looks like a short clip for the earlier HDS lights - before the "Clicky".
Mark Petry
Bainbridge Island, WA
It should fit most HDS lights up to but not including the most recent generation (which are not drilled for clips). Also it will NOT fit the Ti clicky. This looks like a short clip for the earlier HDS lights - before the "Clicky".
Mark Petry
Bainbridge Island, WA
Re: wvaltakis Ti HDS clip & screws
Thank you for that info, much appreciated.
Price drop, let's get this one sold.
Thank you for that info, much appreciated.
Price drop, let's get this one sold.
