Coast is having a sale, a lot of the lower dollar flashlights are sold out but I picked up a 400R to play with.
I liked that it could serve
This is what it says it is.
https://i.imgur.com/u38mhgl.jpg
I have an iFixit infrared thermometer, and Bosch wire and pipe detector, both works with 9V batteries.
I only use them 2-3x times a year,
For Sale Veleno Designs Avant Ti in mint condition, never carried shelf queen.
Description from Veleno Designs website:
-6/4 Titanium
Anyone have the old 75 lumen vision headlamp? The housing was grey in color. I should have bought 10 of them back when they were made.
I have a couple of Soehnle kitchen scale, they function with 3 or 2 AAA batteries.
They need very little power, when I measure something
I have two Malkoff MD2s for sale. They have the high/low switch installed and the current high cri M61W. I’d like $125 shipped each. Both are basically
Last Post By: nmiller Yesterday, 08:02 PMtried to look up a light and got redirected to some lightbulb dealer.
and no malware here.
I need an introduction to LED set up , electronics and troubleshooting.
I am a self taught electronics amateur and need to get more sytematic/formal.
My review of the upcoming Sofirn TF84 tactical flashlight, with 3 switches, dual UI, 18650 battery, remote pressure switch, type-C charging and 90CRI
Last Post By: KG_Tuning Yesterday, 09:20 AMI was behind a new Rav4 today (it's the newest generation Rav4, so either brand new or almost new), and the brake lights are just a single LED on each
Last Post By: -Virgil- 04-09-2021, 10:11 PMEneloop Pros last only 2-3 good years before internal resistance rises to the point that they are difficult to charge and self discharge at an even more
ChrisGarrett Today, 04:20 PMIf I cut it to the same length as a cr123a and leave the second battery in there will it still power on the light?
J_C_S Today, 03:57 PMInterested , but is this still a standard 20mm pcb ?
oldeng95 Today, 03:55 PMThanks for the tips. If I understand correctly "Heavy duty" batteries don't leak.
They provide less power, and maybe they are a good
The stopper screw also looks different. On my two older Rotaries, it's a mini Philips head. The one on yours it looks like either a hex or Torx head.
the.Mtn.Man Today, 03:41 PMBismuth would be heavier than Lead and it`s just as easy to cast, maybe get some Tungsten bar stock and cut a section off that.
Katherine Alicia Today, 03:32 PMI've also placed 2 lithium primary AAs in my weighing scale, with how little power it consumes they will probably outlast the scale. I'll report back
TILL-22 Today, 03:20 PMI couldn’t find a better place to post this and it’s a bit of an odd request for this forum but here goes:
I have a stream light trl1hl
I would store alkaleaks in a bag myself as they can leak. If the device is draining batteries no sense in leaving ANY battery in it at all when not in
Lynx_Arc Today, 02:15 PMive noticed my stools are more narrow excuse me if this is gross.
raggie33 Today, 02:02 PMAlso took me ~3yrs to winnow the excess and get to what worked best for me.
Malkoff drop-in M61 w/ a generic P60 host, crenelated ring,
A freshen up, a little light lube, maybe good as new Mike. Sentimental value is priceless
Coast is having a sale, a lot of the lower dollar flashlights are sold out but I picked up a 400R to play with.
I liked that it could serve
I haven't had a single failure with the pros so far
I would consider my collection small (by flashaholic standards), it's about 36 lights, which includes the lights in my car. I've thought about thinning
greatscoot Today, 11:48 AM
How to make a “heavy” battery?
Thread Starter: J_C_SI couldn’t find a better place to post this and it’s a bit of an odd request for this forum but here goes:
Last Post By: J_C_S Today, 03:57 PMI have a stream light trl1hl