Still trying to figure out what is wrong with my NDI, can someone please tell me how to properly stack the parts into the switch housing? I bought this one second hand here on CPF, here is how it stacks up.
Dropped into the bottom of the housing is a washer, this is a spacer I would assume.
Next is the switch itself.
Next is a thin wavy washer
Next is a little orange rubber washer thingy.
Finally the brass retaining ring is screwed down, holding it all together.
This configuration really doesn't look stock, but it is how I received it.
Dropped into the bottom of the housing is a washer, this is a spacer I would assume.
Next is the switch itself.
Next is a thin wavy washer
Next is a little orange rubber washer thingy.
Finally the brass retaining ring is screwed down, holding it all together.
This configuration really doesn't look stock, but it is how I received it.