Shorty

A Magmod I put together for a friend. He wanted it as short as possible

I have a similar light with the same UX1N Bin LED and it pushes an amazing 8500 Lux at 1 meter. The tailswitch is a dual stage switch with 10-Ohms resistance on low for 180 milliamp and maxes out at 1.4 amps on high.

Mac

Beautiful work, Mac!
:twothumbs:

Here a pic today I took at work of the completed light.

Mac

What a great little light Mac, good work. :thumbsup:

Cliff

That is so nice. How did you get such smooth epoxy? (I assume it's glow powdered)

Greg

Very nice and clean.

What's that in the background on the right? :thinking:

Very nice work ! :goodjob:

That makes a really nice amount of light per its size I bet.

What Driver are you using?
and how is the tailswitch dual stage? (3 clicks, or twist?)

~John

jtice said:

Very nice work ! :goodjob:

That makes a really nice amount of light per its size I bet.

What Driver are you using?
and how is the tailswitch dual stage? (3 clicks, or twist?)

~John

Click to expand...

The Unit in the background is a Mt5 robot from my work.

The Light uses a On Off On1 switch with a 10ohm resistor added for low output. The light is direct drive. The light measures around 8000 lux at 1 meter.


Mac

greg_in_canada said:

That is so nice. How did you get such smooth epoxy? (I assume it's glow powdered)

Greg

Click to expand...

30 minute epoxy mixed with glow powder. You apply a little head to thin in out and flow it around the emitter.


Mac

Would you consider building another to sell, if so what kind of price would i be looking at?

Very nice mod! :twothumbs

cmacclel said:

30 minute epoxy mixed with glow powder. You apply a little head to thin in out and flow it around the emitter.


Mac

Click to expand...

Thanks. I assume you meant to type "heat" not head.

Greg

greg_in_canada said:

Thanks. I assume you meant to type "heat" not head.

Greg

Click to expand...

Yes HEAT.....gee where was mind when I wrote that!


Mac