Something that had been bothering me about me X03, was that I didn't know how far to turn it so it'd be completely locked it out.
Originally I was going to put a line of paint on the tailcap and body, but that'd wear off. So instead I used a 1/64" endmill to mill out a slight mark, then rubbed two coats of red enamel paint into the groove.
Now I always know where the lock-out position is.
NOTE: When viewed horizontally, the lines look much more proportionate - the angle below makes the line on the body look a lot smaller than the one on the tailcap.
-TM
Originally I was going to put a line of paint on the tailcap and body, but that'd wear off. So instead I used a 1/64" endmill to mill out a slight mark, then rubbed two coats of red enamel paint into the groove.
Now I always know where the lock-out position is.
NOTE: When viewed horizontally, the lines look much more proportionate - the angle below makes the line on the body look a lot smaller than the one on the tailcap.
-TM