TinderBox (UK)
Flashlight Enthusiast
just installed an Nichia CS B1 tint in my E0.
I fitted it so that the LED is 3mm further forward than normal.
Now when you remove the original, you have to press on the old LED quite hard to get it to come out.
So it must be glued in somewhat.
my question is, how can i water-proof the LED, without getting glue all over it.
regards.
John.
I fitted it so that the LED is 3mm further forward than normal.
Now when you remove the original, you have to press on the old LED quite hard to get it to come out.
So it must be glued in somewhat.
my question is, how can i water-proof the LED, without getting glue all over it.
regards.
John.