-Modamag Tri-Sink
-3x P3 Cree XR-E
-GoldServe Tri-Flupic driver (low, high, burst, strobe, etc)
-Tri-Bored for 3x 17670 Li-Ion cells in a premium FiveMega Holder
-UCL Lens
-Tailswitch
-Custom Patterned body
The MCR19's have been modified for use on the XR-E's the beam is very nice with a great hotspot. The Flupic driver drives the LED's in burst mode at approximately 1amp each(intermittent use).
It was major PITA trying to fit the super deep Mcr19's into the Mag Head. I had to take .200 of the bottom of the head just to fit them. It wasn't fun trying to hold the head!
On to the Pics
-3x P3 Cree XR-E
-GoldServe Tri-Flupic driver (low, high, burst, strobe, etc)
-Tri-Bored for 3x 17670 Li-Ion cells in a premium FiveMega Holder
-UCL Lens
-Tailswitch
-Custom Patterned body
The MCR19's have been modified for use on the XR-E's the beam is very nice with a great hotspot. The Flupic driver drives the LED's in burst mode at approximately 1amp each(intermittent use).
It was major PITA trying to fit the super deep Mcr19's into the Mag Head. I had to take .200 of the bottom of the head just to fit them. It wasn't fun trying to hold the head!
On to the Pics