DieselDave
Super Moderator,
I am putting this out as a feeler because I am guessing there are more of you out there that would buy this thing if it was well made. If there is enough interest we could find a good hometown leather company and get them to build it. I would want it to be high quality and would pay $50-$60 for the right unit. I want one that will last 10 years.
I want one that holds a Leatherman Wave or Victorinox Mulit-tool plus a ARC AAA and a E2. I lean toward the Wave and E2 because I want it to be as small as possible. Also, if it held the E2 it would probably carry the ARC LS just fine. I am flexible on which torch/Torches it holds but it must hold a multi tool and at least one light. I want it to have a top flap that secures them all in place and I want each item to have it's own slot. Either a snap on or through the belt. I would be thrilled with plain tan/brown harness leather or in black. I absolutely don't want any tooling or other pretty markings except I could go for a CPF brand on it if we could make enough and generate some $$$ for CPF. I have thought of getting one of the 6P and magazine combos but I know I wouldn't be happy with it.
I don't have any leather company contacts but have been to gun shows and seen some custom molded holsters built by small/home based companies and I would love something just like that.
Any better ideas or suggestions keeping in mind we would need a single design to make it cost effective?
I want one that holds a Leatherman Wave or Victorinox Mulit-tool plus a ARC AAA and a E2. I lean toward the Wave and E2 because I want it to be as small as possible. Also, if it held the E2 it would probably carry the ARC LS just fine. I am flexible on which torch/Torches it holds but it must hold a multi tool and at least one light. I want it to have a top flap that secures them all in place and I want each item to have it's own slot. Either a snap on or through the belt. I would be thrilled with plain tan/brown harness leather or in black. I absolutely don't want any tooling or other pretty markings except I could go for a CPF brand on it if we could make enough and generate some $$$ for CPF. I have thought of getting one of the 6P and magazine combos but I know I wouldn't be happy with it.
I don't have any leather company contacts but have been to gun shows and seen some custom molded holsters built by small/home based companies and I would love something just like that.
Any better ideas or suggestions keeping in mind we would need a single design to make it cost effective?