SSC P4 available on a Star?
- Thread starter jsr
- Start date
Help Support Candle Power Flashlight Forum
ginaz
Enlightened
- Joined
- Nov 30, 2004
- Messages
- 508
that would make some mods i'm doing a bit easier!
AlexGT
Flashlight Enthusiast
Not out yet IIRC
AlexGT
AlexGT
IsaacHayes
Flashlight Enthusiast
I have a ultrafire for sale that has an older zled in it. It's mounted on a star. IIRC they are soldered on, one could reflow it off, and reflow a p4 on...
Can anyone tell me if the die sits a bit higher in the SSC P4 over a cree? Therefore requiring less mods to raise/sand the sink/reflector?
I've modded a couple of lights with crees but they could all doing with a bit taking off of the reflector to get a better focus....but I may just swap them out for a SSC P4 as I don't like the cree ring anyway.
I've modded a couple of lights with crees but they could all doing with a bit taking off of the reflector to get a better focus....but I may just swap them out for a SSC P4 as I don't like the cree ring anyway.
Gnufsh
Enlightened
It's higher than a cree 7090 xr-e but lower than a luxeon.
Opto-King
Newly Enlightened
Yes, the P4 is avalible with Al star.
taschenlampe
Enlightened
IsaacHayes
Flashlight Enthusiast
.03" isn't that much of a mod compared to the Cree. You don't even have to attack the reflector if the reflector goes over the body of the led like the IMS27mm, Aleph 1, 3, etc reflectors. Just raise the emitter itself then.
