so i had some old batteries 2 of which measure 1.2v and a 3rd at 1.4 ...when i use these batteries the maxstar draws only 180ma...i also had some weak "C" cells measuring one at less than a volt " .9v " and other 2 at 1.1v the maxstar then tested at 50ma
i thought the maxstar had regulation or some powerpush where it will keep constant current of at least 350ma until batteries are depleted or am i wrong
so i was wondering is mine the only one doing this or does everyone else have this same type of behavior on there maxstar operating really low as volts drop
i thought the maxstar had regulation or some powerpush where it will keep constant current of at least 350ma until batteries are depleted or am i wrong
so i was wondering is mine the only one doing this or does everyone else have this same type of behavior on there maxstar operating really low as volts drop
