A while back I had Chop make me a couple of his EXE heads, he used an IMS 17 reflector at the time. A nice setup and I still use them, he also did a few with turned down McR 20 reflectors.
Since then the McR 18 reflector came out (thanks Don, Cindy and Wayne) and I decided to give it a go.
With a 3/4 in. drill bit in my drill press I drilled out the E1E reflectors, tapped them to accept an Aleph LE, and only had to sand the front of the McR 18 to get it to fit between the LE and the E1E bezel ring/window.
The bits below.
Now a shot of the business end when assembled.
And a shot of the few I have done.
The McR 18 is a great reflector, and IMHO in these small lights create a very nice all around light.
On a side note I hope Chop is out there and all is well.
Thanks for looking.
Since then the McR 18 reflector came out (thanks Don, Cindy and Wayne) and I decided to give it a go.
With a 3/4 in. drill bit in my drill press I drilled out the E1E reflectors, tapped them to accept an Aleph LE, and only had to sand the front of the McR 18 to get it to fit between the LE and the E1E bezel ring/window.
The bits below.
Now a shot of the business end when assembled.
And a shot of the few I have done.
The McR 18 is a great reflector, and IMHO in these small lights create a very nice all around light.
On a side note I hope Chop is out there and all is well.
Thanks for looking.
Last edited:
