how do I switch the P3D to turbo mode?
- Thread starter Miracle
- Start date
Help Support Candle Power Flashlight Forum
Kilovolt
Flashlight Enthusiast
To switch to turbo mode you just tighten the head. I don't know if you got a bad flashlight, but rings in the beam are a Fenix well known trademark.
Kilovolt
Flashlight Enthusiast
I remember that during the development of Lumapower D-Mini there's been some discussion as to the fact that a perfect focusing of a reflector brings out some disturbance in the centre of the beam. This is due to projecting the details of the CREE LED into the hotspot:
http://candlepowerforums.com/vb/showpost.php?p=1737449&postcount=278
As to batteries I can't help you because at 3V I only use primaries. If you just wait for a few days you will be able to find answers in Chevrofreak's next review.
http://candlepowerforums.com/vb/showpost.php?p=1737449&postcount=278
As to batteries I can't help you because at 3V I only use primaries. If you just wait for a few days you will be able to find answers in Chevrofreak's next review.
2jzpower
Newly Enlightened
on the fenix lights using rechargables makes the lights automatically go into turbo mode from what i hear....
use some non rechargables and see what happens
use some non rechargables and see what happens
sonofjesse
Newly Enlightened
P3D and P@D work with RC if you get them to fit in th ep3d.
Mine beam is very splotty too.
Mine beam is very splotty too.
Dobbler
Enlightened
- Joined
- Feb 12, 2007
- Messages
- 503
2jzpower said:
Not with the P3D. Two 3.6v (off the charger at 4.19v) drive the P3D bright, but all modes are available and distinguishable.
