I have added some epoxy blobs (Arctic Alumina, 0,2-0,3 mm thick).
A cutdown toothpick makes nice round blobs.
Now the -contact of the battery can't reach the +contact of the
driver board. It works well.
1. mix a bit of epoxy (isulator)
2. cutdown a toothpick
3. make 3 or 4 blobs (the surface unter the blobs should be rough)
4. blob-mod. ready!
A cutdown toothpick makes nice round blobs.
Now the -contact of the battery can't reach the +contact of the
driver board. It works well.
1. mix a bit of epoxy (isulator)
2. cutdown a toothpick
3. make 3 or 4 blobs (the surface unter the blobs should be rough)
4. blob-mod. ready!
Last edited: