How do you assmeble a Kiu Switch?

h2xblive

Enlightened
Joined
Oct 17, 2006
Messages
295
The link in Kiu's thread with assembly instructions do not work.

I'm trying to install the D-Cell Kiu Switch into my Mag, but because of the aluminum "donut" where the two lamp posts screw in to, the switch installs incorrectly in that it won't go far enough into the Mag.

How is this switch to be installed?
 

DonShock

Flashlight Enthusiast
Joined
Dec 28, 2005
Messages
1,641
Location
Belton Texas
You have to remove the snap ring that sits inside the groove in the body. Just use a screwdriver to pry out one end ahile pushing down at the same time. Once it's started out of the groove, just work your way around and it'll pop out.
 

h2xblive

Enlightened
Joined
Oct 17, 2006
Messages
295
You have to remove the snap ring that sits inside the groove in the body. Just use a screwdriver to pry out one end ahile pushing down at the same time. Once it's started out of the groove, just work your way around and it'll pop out.

Hahaha, I just figured that out...I realized the ring wasn't welded to the inside of the body.

Thanks for your help.
 
Top