Best RCR123 for Fenix Q5?

I am ordering some stuff on lighthound for the Orb wee I am purchasing and I also want to get some rechargeable cells for my Q5 any suggestions??

ScubaSnyder said:

I am ordering some stuff on lighthound for the Orb wee I am purchasing and I also want to get some rechargeable cells for my Q5 any suggestions??

Click to expand...

I just bought a P3D Q5 with AW RCR123A and an AW 139 charger from Fenix-Store. Don't know how that setup performs but will find out.

Anyone here with that same setup willing to share your experiences?

Thanks.

will the added voltage increase the light output or only affect runtime?

These http://www.lighthound.com/index.asp?PageAction=VIEWPROD&ProdID=2190 are my favorite RCR123s. I have 8 or 10 of them now and never had any of poor quality. They have pretty good run-time too. At the higher voltage you might lose the low and medium modes on the fenix lights. The AW brand is also very good but have slightly less capacity. If you want to have all of your output levels you'll have to go with 3.0 volt li-ions like these. http://batteryjunction.com/rc390reliba.html

Whatever brand RCR123 you decide on, I recommend getting ones with protection circuitry, like the ones I posted links to.

Good luck

That's easy.. AW cells all the way. Accept no substitutes.:rock:

AW only.

AW......

AW cells will be the choice since there are no battery station rcr123s

AW is great to deal with. Great communications. I ordered some late one night and received a shipping comfirmation the next day.

+1 AW

Shagbd said:

will the added voltage increase the light output or only affect runtime?

Click to expand...

I didn't see an answer to this question...I would like to know as well.

I'd go with AW's cell. Didn't someone just have a battery station cell blow up on them?

My father had a BS RCR123 900 battery blow up on him in his overnight bag sometime during his drive and overnight stay at a hotel. He had two with him and the one that died had apparently gotten very hot, the shrink wrap had contracted quite a bit and the protection slice popped off.

Patriot36 said:

At the higher voltage you might lose the low and medium modes on the fenix lights. The AW brand is also very good but have slightly less capacity. If you want to have all of your output levels you'll have to go with 3.0 volt li-ions like these. http://batteryjunction.com/rc390reliba.html

Click to expand...

I have both the AW ones and the 3.0v Tenergy ones from Battery Junction. Both work equally aswell and I can confirm you dont loose any of the output levels using the AW's.

Shagbd said:

will the added voltage increase the light output or only affect runtime?

Click to expand...

If I'm correctly reading post #116 on the thread below, then the runtime will be one hour. Also the light output will not be affected.
https://www.candlepowerforums.com/threads/172795&page=4

brunt_sp said:

If I'm correctly reading post #116 on the thread below, then the runtime will be one hour. Also the light output will not be affected.
https://www.candlepowerforums.com/threads/172795&page=4

Click to expand...

Correct mate, light output wont change.
1hour with 2x rcr123
1.5hours with 3x rcr123