kurni
Enlightened
I need 14mm and 10mm diameter; approximately 1mm thick or more.
Any idea? I'm in Sydney / Australia.
Any idea? I'm in Sydney / Australia.
Where can I get copper discs?
- Thread starter kurni
- Start date
Help Support Candle Power Flashlight Forum
Long John
Flashlight Enthusiast
Any hardware store should have copper water/gas tube end-caps.
You have to saw/dremel the discs out of them.
BTW: the complete copper cap works great as heatsink
Best regards
____
Tom
You have to saw/dremel the discs out of them.
BTW: the complete copper cap works great as heatsink
Best regards
____
Tom
Illum
Flashaholic
Long John
Flashlight Enthusiast
You are welcome Itn
For best performance the cap should fit pressed contact to the flashlight body/tube/head by using thermal-paste.
Later I will show an example.
Best regards
____
Tom
For best performance the cap should fit pressed contact to the flashlight body/tube/head by using thermal-paste.
Later I will show an example.
Best regards
____
Tom
Long John
Flashlight Enthusiast
At this mod I used a copper-endcap, works perfect :thumbsup::
https://www.candlepowerforums.com/threads/157529
Paul, kurni is located in Australia
Best regards
____
Tom
https://www.candlepowerforums.com/threads/157529
Paul, kurni is located in Australia
Best regards
____
Tom
Sigman
* The Arctic Moderator *
I wondered why the bank was selling "heatsinks"! 
kurni
Enlightened
Thanks for all the response; I'll try to find the copper end cap and the penny / dime; I have a few US coins stashed somewhere leftover from visiting Disney World Florida. I also have some leftover copper plates coming; I will try to cut them. I just have to remember to wear safety / swimming goggles as I still remember a shard of copper flew to my eyes when I was very little; I don't remember why I cut coppers back then.
