I'd like to mod a 3D mag with a Seoul and this driver:
http://www.dealextreme.com/details.dx/sku.6190
and I've got a couple of questions.
First of all, would it work?
Second, how would I wire it? I assume the positive wire from the switch would be soldered to the center of the bottom side of the board and the negative wire from the switch would be soldered to the outside ring. Is this correct?
Finally, would I need to heat sink the board and how would I do this?
Thanks in advance for your help.
http://www.dealextreme.com/details.dx/sku.6190
and I've got a couple of questions.
First of all, would it work?
Second, how would I wire it? I assume the positive wire from the switch would be soldered to the center of the bottom side of the board and the negative wire from the switch would be soldered to the outside ring. Is this correct?
Finally, would I need to heat sink the board and how would I do this?
Thanks in advance for your help.