Fallingwater
Flashlight Enthusiast
In working with a SSC P4, its dome has collected a lot of assorted crud and dust. How do I get it off without damaging the dome?
Thanks.
Thanks.
Cleaning a SSC P4's gummy dome
- Thread starter Fallingwater
- Start date
Help Support Candle Power Flashlight Forum
jzmtl
Flashlight Enthusiast
Canned air and ethanol cotton swab works well for me.
Fallingwater
Flashlight Enthusiast
I thought of that, but I was worried that alcohol could damage the dome...
Hogokansatsukan
Flashlight Enthusiast
Have cleaned several with alcohol and a swab, but not cotton. Pick up the swabs that look like little sponges.
Isopropyl Alcohol on a Q-tip works every time with no threads left on the dome. Give it a minute to evaporate off the dome and leads before powering up. Isopropyl Alcohol is recommended by Seoul Semiconductor, from the .pdf on pg.15:
• This device should not be used in any type of fluid such as water, oil, organic solvent and etc. When washing is required, IPA(Isopropyl Alcohol) should be used.
• This device should not be used in any type of fluid such as water, oil, organic solvent and etc. When washing is required, IPA(Isopropyl Alcohol) should be used.
TORCH_BOY
Flashlight Enthusiast
I use a Camera lens Blower brush
rizky_p
Flashlight Enthusiast
i use a spit and fingger and it works okay even on P7, probably not the most hygienic 
Now that i read all the post, i'll use alcohol instead.
Now that i read all the post, i'll use alcohol instead.
