I saw on cpf a while ago (but cand seem to find them now) a spacer, it was just a ring that fit between the tailcap and body of a m*g lite. I need one for my 2 c M*g. Does anyone know where to get theese?
Last edited:
-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
Sold/Expired Tail cap spacer for M*g?
- Thread starter vestureofblood
- Start date
Help Support Candle Power Flashlight Forum
Re: Tail cap spacer fro M*g?
Thanks Choppers for your reply. This one is actualy a bit different than the one I think I saw. What I am going to do is cut the tailspring to fit inside the tail cap, remove the coating on the bottom of the inside for connection, and spip 2x18650s into the light so all I realy need is one that is about 2 or 3 mm thick, it looked sort of like a very thick snap ring. Any one seen theese?
Thanks Choppers for your reply. This one is actualy a bit different than the one I think I saw. What I am going to do is cut the tailspring to fit inside the tail cap, remove the coating on the bottom of the inside for connection, and spip 2x18650s into the light so all I realy need is one that is about 2 or 3 mm thick, it looked sort of like a very thick snap ring. Any one seen theese?
gswitter
Flashlight Enthusiast
Re: Tail cap spacer fro M*g?
.
.
Last edited:
gswitter
Flashlight Enthusiast
Re: Tail cap spacer fro M*g?
Or here:
http://www.lighthound.com/index.asp?...OD&ProdID=2653
Or how 'bout this?
https://www.candlepowerforums.com/threads/178764
I don't remember if a MagRing2 and a shortened spring will provide enough room for 2x AW "C"s. You might have to slide the switch up, or still machine the tailcap a bit.
Or here:
http://www.lighthound.com/index.asp?...OD&ProdID=2653
Or how 'bout this?
https://www.candlepowerforums.com/threads/178764
I don't remember if a MagRing2 and a shortened spring will provide enough room for 2x AW "C"s. You might have to slide the switch up, or still machine the tailcap a bit.
Last edited:
GLOCK18
Enlightened
Re: Tail cap spacer fro M*g?
Do you means these ( never mind )
https://www.candlepowerforums.com/threads/178764
Do you means these ( never mind )
https://www.candlepowerforums.com/threads/178764
Re: Tail cap spacer fro M*g?
Or this is another option
https://www.candlepowerforums.com/threads/160004
Or this is another option
https://www.candlepowerforums.com/threads/160004
Re: Tail cap spacer fro M*g?
It'll fit with the shortened spring, or an AW driver that is a hair shorter than the standard switch and no need to mess with the spring.
It'll fit with the shortened spring, or an AW driver that is a hair shorter than the standard switch and no need to mess with the spring.
Similar threads
Latest posts
-
-
-
More EV fires after salt water flooding
- Latest: mrfixitman
-
-
-
