Excessive heat is a big issue for high power flashlights specially for LEDs.
I was allways thinking about better and more efficient way to cool down high power LED such as P7
I have made this prototype of M*g look host with oversized heat sink integrated with finned body and a seperate finned head.
Heat sink area has massive amount of material which is one piece with battery barrel.
Entire length of battery barrel, switch area up to neck is fine finned and barrel has slightly larger diameter than "D size M*g.
This is a host only and not a complete flashlight. You will get body/heat sink plus O'ring and head plus O'ring.
Body takes a towerless M*g "C" switch, "C" size protected cell and M*g "C" tail cap.
Note: front of switch compartment has 21mm diameter and 10mm deep space if you decided to use any regulator/controller.
Head takes "C" or "D" or Crown bezel with camless original or aluminum reflector and UCL.
Picture shows heat sink size comparison of M*g "C", M*g "D" and Ice Cold P7
Red one at left is M*g "D", black one is Ice Cold P7 and right one is a M*g "C"
Why spend a lot of $$$ for cut down+back and forth shipping your M*g body and then heat sink from elsewhere while you can have high efficieny finned short body and heat sink machined from one piece aluminum bar in HA black.
Price will be maximum $50 or less depends on quantity.
Please do not pay at this time.
Any SERIOUS interest?
Last edited: