roguesw
Enlightened
Hi everyone, I find I dont use this much anymore.
This LE was built for my Aleph Mule McClickie.
Details.
SSC P7 on Sandwich Shoppe MCPCB run on GD1000 housed in a XR-Can.
Run time, on 1 RCR123, it gets about 30-40 minutes run time before it drops out of regulation.
The P7 is not centered because of the holes in the shoppe
MCPCB, its off centre but it was designed to be used in a Mule so
it doesnt affect the beam.
The P7 basically emits a big cone of light that is very usefull for lighting.
I'd rather trade this than sell it because i realise its hard to sell a LE.
What I would like to trade for is the following options.
option A
1x 0.55 Inch Flupic 1 Amp burst (SSC limit) + 1x 0.55 Flupic 1.2 Amp burst boards.
option B
1 x 0.55 Flupic 1.2 Amp burst board + XR-Can + Cree R bin emitter.
Thanks for looking guys.
Best regards
Des
This LE was built for my Aleph Mule McClickie.
Details.
SSC P7 on Sandwich Shoppe MCPCB run on GD1000 housed in a XR-Can.
Run time, on 1 RCR123, it gets about 30-40 minutes run time before it drops out of regulation.
The P7 is not centered because of the holes in the shoppe
MCPCB, its off centre but it was designed to be used in a Mule so
it doesnt affect the beam.
The P7 basically emits a big cone of light that is very usefull for lighting.
I'd rather trade this than sell it because i realise its hard to sell a LE.
What I would like to trade for is the following options.
option A
1x 0.55 Inch Flupic 1 Amp burst (SSC limit) + 1x 0.55 Flupic 1.2 Amp burst boards.
option B
1 x 0.55 Flupic 1.2 Amp burst board + XR-Can + Cree R bin emitter.
Thanks for looking guys.
Best regards
Des
