• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired FS: (SOLD) Aleph LE based on Piglet Board (SOLD)

ROK

Enlightened
Joined
Sep 30, 2004
Messages
261
Location
Dynamic Land
This is not a used one, built today.
You can use this one for Aleph1, 2(with McR20-S) & 3 with 1xCR123A or 1xLiIon cell.
(If you use this LE for Aleph1 & 3, please isolate the bottom of reflector or LED leads to prevent the short circuit)

SOLD $98 shipped worldwide by registered airmail.

- Converter: Piglet Board, 50mA/500mA
- Current setting is Mode 2 (If you want, I'll set another mode before shipment)
- Fully potted with AA epoxy and used teflon wire
- LED: SSC P4 U2SWOH
- Soldered 0.030" copper disk on the bottom of P4 for proper focus

Aleph_LE_Top-1.jpg
Aleph_LE_Bottom.jpg


If you are not familiar with Piglet Board, refer to following manual.
goldservevxpigletaf1.jpg


Thanks for looking.
 
Last edited:

octaf

Flashlight Enthusiast
Joined
Mar 12, 2008
Messages
1,268
Re: FS: Aleph LE based on Piglet Board

8 minutes flat !
That was fast.
I have one of this myself from ROK.
Great modder. :wave:
 

ROK

Enlightened
Joined
Sep 30, 2004
Messages
261
Location
Dynamic Land
Re: FS: Aleph LE based on Piglet Board (SOLD)

:thanks: donn and PM sent with PP addy.
 

ROK

Enlightened
Joined
Sep 30, 2004
Messages
261
Location
Dynamic Land
Re: FS: Aleph LE based on Piglet Board (SOLD)

Got PP and will ship it out on Monday.
:thanks:
 
Top