-
You must be a Supporting Member to participate in the Candle Power Forums Marketplace.
You can become a Supporting Member.
Sold/Expired WTB: P7 already attached to a D cell Maglite heatsink.
- Thread starter Orion
- Start date
Help Support Candle Power Flashlight Forum
Visible EM Wave
Enlightened
Orion, Britelumens sells D bin P7 along with Mag D heat sinks. Maybe you can try PM him if he can put the P7 onto the D sink for you in some additional cost? Jo @ Britelumens is a good guy. His work is clean & professional.
Sorry Jo if I give you trouble here.
Sorry Jo if I give you trouble here.
Sabrewolf
Flashlight Enthusiast
Orion, Britelumens sells D bin P7 along with Mag D heat sinks. Maybe you can try PM him if he can put the P7 onto the D sink for you in some additional cost? Jo @ Britelumens is a good guy. His work is clean & professional.
Sorry Jo if I give you trouble here.
If jo is too bizzy, i will take care of that one :thumbsup:
If you want wires soldered to the P7 too thats fine
I actually bought those parts from Britelumens too :wave:
It is a P7 DSXPJ Bin, and a black anodized heatsink.
Super
Britelumens
Enlightened
Hi Orion,
I have them all ready to ship in Mag C and Mag D heatsink with DSXPJ emitters. If you need I can epoxy them for you with Artic Silver in advance.
Oh no...not at all, always ready to serve
With regards,
Jo @ Britelumens
I have them all ready to ship in Mag C and Mag D heatsink with DSXPJ emitters. If you need I can epoxy them for you with Artic Silver in advance.
Sorry Jo if I give you trouble here.
Oh no...not at all, always ready to serve
With regards,
Jo @ Britelumens
Britelumens
Enlightened
Sounds good to me, Britelumens. If you could PM me with the cost as well as where I would send you a bank check, that would be great!
Hi Orion,
I apologized that I could only accept PayPal as a mode of payment.
Do you have a Paypal? If you have, you can go to this link P7 and parts to see what you need and the cost.
With regards,
Jo @ Britelumens
