DBS V2 tail cap keeps comming unscrewed on the inside????

fire-stick · Nov 30, 2008

The last few times I have taken my tail cap off the aluminum metal disk on the inside keeps coming unscrewed.

I tightened it a little with the tip of my knife, but it didn't work so well. Is there a certain tool I should use to tighten it?

After I tighten it will it stop of is there something wrong with it?

Thanks

-Scott

TooManyGizmos · Nov 30, 2008

:naughty:

Don't tighten the end cap so tight ... when you change batteries.

That will help some.

It is a common problem .

FireStik · Dec 2, 2008

You can use a needle nose pliers to tighten that insert - one jaw in each hole.

WadeF · Dec 2, 2008

Don't ruin your knife, do as FireStik said and get some fine needle nose pliers so you can grab both holes and properly tighten it. I don't have any problems with mine coming loss, I tighten it pretty good.

fire-stick · Dec 2, 2008

I don't tighten it hard just kida snug.. alough I will start putting it on a a little softer..

I'll find a real small set of nedle nose pliers and try that... thanks

DBS V2 tail cap keeps comming unscrewed on the inside????

fire-stick

Enlightened

TooManyGizmos

Flashlight Enthusiast

FireStik

Newly Enlightened

WadeF

Flashlight Enthusiast

fire-stick

Enlightened

Similar threads

Latest posts