Mike Painter
Flashlight Enthusiast
- Joined
- Sep 16, 2002
- Messages
- 1,863
10 foot lengths of 3/4 inch colored EMT tube.
These are actually about .8 inches so an 18650 will fit with room to spare.
I have a light that has four C cells in groups of two and I like the idea.
An over/under light made of two sections of tube would be a nice size. (Three in a triangle do not feel good in my hand)
Two, four, six... would just be a matter of cutting off the right length.
A mag head might fit over the two of them but how would you fasten them together so they looked good.
Two tubes. Two P7's. A dimmer on one and a separate switch for the second one?
Series is no problem. If you put a spacer between the batteries with wires fastened on both sides you could hook them up in parallel at the head.
And that's about as far as I have gone. Any ideas?
These are actually about .8 inches so an 18650 will fit with room to spare.
I have a light that has four C cells in groups of two and I like the idea.
An over/under light made of two sections of tube would be a nice size. (Three in a triangle do not feel good in my hand)
Two, four, six... would just be a matter of cutting off the right length.
A mag head might fit over the two of them but how would you fasten them together so they looked good.
Two tubes. Two P7's. A dimmer on one and a separate switch for the second one?
Series is no problem. If you put a spacer between the batteries with wires fastened on both sides you could hook them up in parallel at the head.
And that's about as far as I have gone. Any ideas?
