• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired SOLD - 3D - Quad P7 in 3" FM head in Britelumens HAIII

nailbender

Flashlight Enthusiast
Joined
Nov 9, 2008
Messages
3,682
Location
North Carolina
Hi All

Here is a rather unique 3D - Quad P7 with LZ heat sink in a FM 3" Delghi head and finished in Britelumens HAIII.

3D HAIII modded for 4 AW C cell IMR
3" FM Delghi Head finished in Britelumens HAIII
Quad P7 DSWOJ
HAIII by Britelumens
Led Zeppelin's heat sink
IMS Smooth Reflectors
Direct Drive with D2flex dimming board by TaskLed
Switch modded for momentary function with Milspec silver coated wires
PVC sleeve for AW IMR C Cells
Tail Cap modded for C Cells

This is the brightest Led light that I have used. When taken outside last night I was surprised that it had the throw of a aspheric R2 but instead of having spill about 70' wide it had spill of 200' wide.

I was also pleased but not surprised that after 15 minutes on high the light was only moderately warm, any other tri-P7 mag would have been very very hot. LZ's heat sink is just great.

I was also surprised that there was almost no artifacts when wall hunting. There was just a huge brilliant hotspot and well defined spill. Other than that I was amazed at how it just lit up the whole room.


Price of the light is $525 shipped CONUS Int. Quoted
CC is 4%


I also have new AW IMR C Cells for $15 if needed.

Here are the pictures.

sink.jpg

Led Zeppelins super heat sink

bottomsink.jpg

another shot of the sink and the D2flex

front.jpg

Front of light with Leds

LayingDown.jpg

Another shot

Standing.jpg


Final shot of this great light


Thanks

Dave

I can take wall shots of the beam if needed but outside shots are not possible because of my inferior camera and if I buy better camera then I would have to give up another light or two. :D
Sorry for the original post as something ate half of it when posted.
 
Last edited:

donn_

Flashaholic
Joined
Oct 10, 2007
Messages
8,067
Location
Great South Bay, LINY
Re: 3D - Quad P7 in 3" FM head in Britelumens HAIII

Hi All

Here is a rather unique 3D - Quad P7 with LZ heat sink in a FM 3" Delghi head and finished in Britelumens HAIII.

3D HAIII modded for 4 AW C cell IMR
3" FM Delghi

What is an "FM 3" Delghi head" and what is the price?
 

nailbender

Flashlight Enthusiast
Joined
Nov 9, 2008
Messages
3,682
Location
North Carolina
Re: 3D - Quad P7 in 3" FM head in Britelumens HAIII

What is an "FM 3" Delghi head" and what is the price?


That is what Jo with britelumes called this FM 3 inch head so I copied as he wrote but now you can see.

Sorry for the broken post to start with something ate most of the first post.

Dave
 
Top