Here is a new Patent Pending design for your viewing pleasure. It is a custom tailcap with a 5.5mm coaxial female connector that can be hooked up to a 12V source, like a car cigarette lighter. It includes a rod that goes from the tailcap to the spring on the rear of the Mag switch. I'm gauging interest in the availability of two kits. One kit will include the custom tailcap and the rod for $54.95 + shipping. The other kit will include the above plus a voltage regulator and the cigarette lighter cord for $77.95 + shipping. The regulator would allow variable voltage to the Mag switch, set by dial, and the cord would be 6' long. The regulator will allow the use of various LEDs and bulbs that require less than 12 volts.
Shipping will be:
$3.95 US for Kit 1
$5.95 US for Kit 2
$12.95 International to most destinations, either kit. May be more for multiple kits.
Edit 10/26/09: These will be available in limited quantities once per month. I will take orders for them until the last day of each month then will have them made and shipped about one week after the end of the month. Due to the custom nature of these and the limited demand I ask that payment be made by the last day of the month. Paypal is gofastalot99(at)aol.com [remove (at) and replace with @]. PM me for USPS MO payment instructions.
Edit 2/24/10: I won't be responsible for a failure caused by any mods made to the light, especially hot-wires, hi-output LEDs and/or multiple LED set-ups.
Kit 1
Kit 2
Shipping will be:
$3.95 US for Kit 1
$5.95 US for Kit 2
$12.95 International to most destinations, either kit. May be more for multiple kits.
Edit 10/26/09: These will be available in limited quantities once per month. I will take orders for them until the last day of each month then will have them made and shipped about one week after the end of the month. Due to the custom nature of these and the limited demand I ask that payment be made by the last day of the month. Paypal is gofastalot99(at)aol.com [remove (at) and replace with @]. PM me for USPS MO payment instructions.
Edit 2/24/10: I won't be responsible for a failure caused by any mods made to the light, especially hot-wires, hi-output LEDs and/or multiple LED set-ups.
Kit 1
Kit 2
Last edited: