RUN TIMES?
- Thread starter how2
- Start date
Help Support Candle Power Flashlight Forum
My NiteCore EZAA (warm), on a Sanyo Eneloop,
runs perhaps 45 minutes before starting to slowly drop.
I've always felt this HIGH mode was way too bright.
Something lasting ~ 2 hours would've been my choice.
OTOH, many folks (unlike me) are simply NUTS about BRIGHTNESS !
_
runs perhaps 45 minutes before starting to slowly drop.
I've always felt this HIGH mode was way too bright.
Something lasting ~ 2 hours would've been my choice.
OTOH, many folks (unlike me) are simply NUTS about BRIGHTNESS !
_
DimeRazorback
Flashlight Enthusiast
Surefire M6, MN21.
20 Minutes, "500" Lumens.
6xCR123
EDIT -
just realised this was in the LED section :laughing:
20 Minutes, "500" Lumens.
6xCR123
EDIT -
just realised this was in the LED section :laughing:
Marduke
Flashaholic
Mag Solitaire 1xAAA: 12 minutes to 50%, ~1.5 lumens
Fenix L0D 1x10440: 10 minutes 23 seconds to 50%, ~200 lumens
Fenix L0D 1x10440: 10 minutes 23 seconds to 50%, ~200 lumens
Kestrel
Flashaholic
SureFire E1 "Room Sweeper" by 'Milky'.
P7 LED, 1xIMR16340, 12-13 minutes on 'high' (a 'low' is provided by a McE2S tailcap mod).
~ 500 lumens? (initial)
P7 LED, 1xIMR16340, 12-13 minutes on 'high' (a 'low' is provided by a McE2S tailcap mod).
~ 500 lumens? (initial)
I came to the light...
Flashlight Enthusiast
- Joined
- Nov 4, 2007
- Messages
- 1,059
2xIMR16340+LF IMR-9... haha runtime.
For LEDs, probably EagleTac P10C w/16340 at 30 minutes (or Ra Clicky at 10s)
For LEDs, probably EagleTac P10C w/16340 at 30 minutes (or Ra Clicky at 10s
)
