Hey guys, i replaced the xr-e q5 board in my edc with the one from kaidomain that claims to be xp-g r5.
I'd just like some opinions cause im not sure if the beam is good or needs to be adjusted. The driver is 3 mode, H,M,S. High is too high @1.65A draw from an rcr123 battery for such a small light, but i don't have any other driver, and i never use high for more than 1 minute.
The flashlights are 70cm from the wall, both on high. I'll be taking some outdoor beam shots as well, the only reference light i have is a Spiderfire p7 light that runs DD, it's @3A with a fresh cell in the photo.
P7 left, xp-g right
I'd just like some opinions cause im not sure if the beam is good or needs to be adjusted. The driver is 3 mode, H,M,S. High is too high @1.65A draw from an rcr123 battery for such a small light, but i don't have any other driver, and i never use high for more than 1 minute.
The flashlights are 70cm from the wall, both on high. I'll be taking some outdoor beam shots as well, the only reference light i have is a Spiderfire p7 light that runs DD, it's @3A with a fresh cell in the photo.
P7 left, xp-g right