how can i diassamble a tk11 head?
the stock emmiter in mine is a bit off center and i am planning on an xpg mod.
there are two holes in the surface under the treads in the head. but before i make a tool to fit in those i want to know if thats the right way.
are the head and the bezel a single piece of alu.?
the stock emmiter in mine is a bit off center and i am planning on an xpg mod.
there are two holes in the surface under the treads in the head. but before i make a tool to fit in those i want to know if thats the right way.
are the head and the bezel a single piece of alu.?