• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired Sold: 17670 parallel 3.7v holders (all gone)

Drywolf

Flashlight Enthusiast
Joined
Feb 18, 2008
Messages
1,246
Location
Golden Poppy State
I needed one of these, but I had a few extra made so I could offer them to you. I tested them in a tri bored 1.25-.50 D mag and they work and fit nicely (88mm). These are parallel 3.7volts. I would like $35.00 PayPal (no trades) a piece shipped to "CONUS only" with confirmation and no fees. This will cover about what I paid per unit. Please PM for PP address.

17670_3P.JPG
 
Last edited:

Drywolf

Flashlight Enthusiast
Joined
Feb 18, 2008
Messages
1,246
Location
Golden Poppy State
Re: FS: 17670 parallel holders

What size range?
Do you mean 1.5~ 2 D sized mag :popcorn:
They are made to fit just like the serial 3 x 17670 holders you can find here on BST. They fit a tri bored 1.5 or 1.25 D mag. They are 88mm in length from negetive contact to end of positive button. They were put together by member mdocod.
Thanks,
Frank
 

Drywolf

Flashlight Enthusiast
Joined
Feb 18, 2008
Messages
1,246
Location
Golden Poppy State
Re: FS: 17670 parallel holders

I believe they can, as they are the same size as the 3 x 17670 (11.1v) in serial that I own. I do not own an M6 so I cannot try it. These are very nice as they do not need to be completely disassembled to remove the cells. These holders provide 3.7v with longer run times; they do not have a charging port.
Thanks,
Frank
 

alantch

Enlightened
Joined
Jul 9, 2006
Messages
484
Location
GMT +8
Re: FS: 17670 parallel 3.7v holders

Any ideas on what I can run this with if I stick it in an M6?
 
Top