Fitorch        
Results 1 to 5 of 5

Thread: Proper Assembly for NDI Switch Housing.

  1. #1
    Flashaholic* F250XLT's Avatar
    Join Date
    Dec 2008
    Location
    I can see the Windmills...
    Posts
    2,161

    Default Proper Assembly for NDI Switch Housing.

    Still trying to figure out what is wrong with my NDI, can someone please tell me how to properly stack the parts into the switch housing? I bought this one second hand here on CPF, here is how it stacks up.

    Dropped into the bottom of the housing is a washer, this is a spacer I would assume.

    Next is the switch itself.

    Next is a thin wavy washer

    Next is a little orange rubber washer thingy.

    Finally the brass retaining ring is screwed down, holding it all together.

    This configuration really doesn't look stock, but it is how I received it.

  2. #2

    Default Re: Proper Assembly for NDI Switch Housing.

    That sounds close to the order in my NDI, but I don't have a "thin wavy washer." What exactly is that piece?

  3. #3
    Flashaholic* F250XLT's Avatar
    Join Date
    Dec 2008
    Location
    I can see the Windmills...
    Posts
    2,161

    Default Re: Proper Assembly for NDI Switch Housing.

    Nobody has knowledge of this, or has one they can take apart to verify?

  4. #4
    Flashaholic*
    Join Date
    Oct 2006
    Location
    Bay Area, CA
    Posts
    1,095

    Default Re: Proper Assembly for NDI Switch Housing.

    My NDI goes:

    Tailcap (with black rubber switch cover dropped into it, of course), then switch module, then rubber orange ring dropped onto that, then finally the brass ring. That's it, how mine arrived.



    The spring protrudes through the orange ring, and the top layer of the orange ring ends up being hugged by the inner edge of the brass ring.
    Last edited by swxb12; 02-26-2010 at 06:47 PM. Reason: added a photo

  5. #5
    Flashaholic* F250XLT's Avatar
    Join Date
    Dec 2008
    Location
    I can see the Windmills...
    Posts
    2,161

    Default Re: Proper Assembly for NDI Switch Housing.

    Quote Originally Posted by swxb12 View Post
    My NDI goes:

    Tailcap (with black rubber switch cover dropped into it, of course), then switch module, then rubber orange ring dropped onto that, then finally the brass ring. That's it, how mine arrived.



    The spring protrudes through the orange ring, and the top layer of the orange ring ends up being hugged by the inner edge of the brass ring.

    Thank you for that clarification, I really do appreciate it

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •