Replacing a ITP SA2 eluma boot
- Thread starter SMC527
- Start date
Help Support Candle Power Flashlight Forum
If it is the tail switch boot you're talking about, just screw open the switch holder inside the tailcap.
Use some small nose pliers or cirlclip pliers in the 2 holes you see in the switch holder.
Then take out the washer and the boot.
The boot seems to be a bit odd size, 13 or something mm.
But, these from shiningbeam fit:
http://www.shiningbeam.com/servlet/the-17/Assorted-Color-Silicone-Tailcaps/Detail
You need to trim down the knob inside the boot.
Also, reverse switch and boot should come with the light.
Use some small nose pliers or cirlclip pliers in the 2 holes you see in the switch holder.
Then take out the washer and the boot.
The boot seems to be a bit odd size, 13 or something mm.
But, these from shiningbeam fit:
http://www.shiningbeam.com/servlet/the-17/Assorted-Color-Silicone-Tailcaps/Detail
You need to trim down the knob inside the boot.
Also, reverse switch and boot should come with the light.
Last edited:
