Optic fitment requirement question.

waddup · Sep 14, 2010

I recently removed the optic on my electrolumens Decree to instal a 3 mode driver.

http://elektrolumens.com/DeCree/DeCree-XPG.html

when re assembled, the beam is different, it used to be almost all a tight throwy beam, now it has some flood/ringy spill as well which i dont like.

is optic fitment more complicated then just glueing it to the heatsink?

waddup · Sep 14, 2010

anyone know anything about removing and replacing optics?

in the dark here.......

jabe1 · Sep 14, 2010

If I were you, I'd give Wayne a call. AFAIK fitment does matter...at least depth of the LED.

waddup · Sep 14, 2010

one mo time,

seeking cliff notes on optics / optics fitment.

AnAppleSnail · Sep 14, 2010

waddup said:
one mo time,

seeking cliff notes on optics / optics fitment.

Well, the position of the LED relative to the optic is critical. Height and centering mainly. But even sub-millimeter errors cause trouble in reflectors.

The only TIR light I have is self-centering, not very throwy, and I haven't changed the LED height. Call Wayne and see what he has to say. The DIY flashlight stuff will tell you some about it. Must be centered. Must be at the focal point of the optic.

^Gurthang · Sep 15, 2010

Like Snail wrote, small change in the emitter placement will make ALL the difference. Lots of "trial & error" adjustments I'd say.... good luck.

Optic fitment requirement question.

waddup

Flashlight Enthusiast

waddup

Flashlight Enthusiast

jabe1

Flashlight Enthusiast

waddup

Flashlight Enthusiast

AnAppleSnail

Flashlight Enthusiast

^Gurthang

Flashlight Enthusiast

Similar threads

Latest posts