Solarforce Masterpiece Pro-1 with 2 x CR123s?
- Thread starter gnlw
- Start date
Help Support Candle Power Flashlight Forum
bigchelis
Flashlight Enthusiast
You will not get full power with just a single 18650. It needs 6V.
Solarforce Masterpiece_____XR-E R2___________2 IMR 16340____________226.2 ______ 1 sec_____1,947______48,675___
__________________________________________________ _____________ 215.4_______30 sec_______________________
_____________________________________________________________________________ 213.1_______1 min________________________
__________________________________________________ _____________________________211.1_______2 min________________________
______________________________________________________________________________210.0_______3 min________________________
Solarforce Masterpiece_____XR-E R2___________2 IMR 16340____________226.2 ______ 1 sec_____1,947______48,675___
__________________________________________________ _____________ 215.4_______30 sec_______________________
_____________________________________________________________________________ 213.1_______1 min________________________
__________________________________________________ _____________________________211.1_______2 min________________________
______________________________________________________________________________210.0_______3 min________________________
FroggyTaco
Flashlight Enthusiast
Jose he was asking about using 2 3V CR123a cells so he should get full power for a little while until the cells sag enough from the current draw.
recDNA
Flashaholic
- Joined
- Jun 2, 2009
- Messages
- 8,761
I do. I tried 3 X CR123 and I couln't see any diff. On the other hand I've never used it for more than 10 minutes at a time.
recDNA
Flashaholic
- Joined
- Jun 2, 2009
- Messages
- 8,761
Never ran it to empty and since I do short bursts I will never have any way to estimate. Batteries cost money so I don't intend to do a runtime test.
