soalrforce flashlight head problem

maxsutter

Newly Enlightened
Joined
Jun 22, 2010
Messages
43
I popped out the glass -

I dod not pay close attention

which way is the glass supposed to go back in??
Putting it back fromthe top I cant seem to wedge the rubber around it - It does not seem very secure this way.
 

bshanahan14rulz

Flashlight Enthusiast
Joined
Jan 29, 2009
Messages
2,819
Location
Tennessee
glass should fit in rubber, rubber should fit in from the front, and then the front metal piece screws in to hold the glass and rubber in.
 

maxsutter

Newly Enlightened
Joined
Jun 22, 2010
Messages
43
ok I see the sharp bezel screws it in -

I had pulled it out of the torch module that is why it was not securing front the front end.
 
Top