scott011422
Newly Enlightened
- Joined
- Feb 5, 2008
- Messages
- 104
Hey all, Well after 4 years of daily use, I have a burnt spot in the middle of my led. Over the course of an hour I went from 100% with a little brown spot to maby 20 % and mostly dark spot. Time to replace....And maby upgrade!
So I've been off the site and out of the loop for awhile, And am a little short on time. So I was hopping you guys could help me with a replacement. Now I have no problems ordering another one. Have nothing bad to say about the P3D at all. But has anything come out that out performs it? Here are the specs I'd like to stay with:
Must run on CR123's
Must be mininum of 215 lm
Roughly the same size, but can be smaller or a little larger.
4.5 x .875 roughly with tape measure.
I currently run the textured bezal.
Thanks guys!
So I've been off the site and out of the loop for awhile, And am a little short on time. So I was hopping you guys could help me with a replacement. Now I have no problems ordering another one. Have nothing bad to say about the P3D at all. But has anything come out that out performs it? Here are the specs I'd like to stay with:
Must run on CR123's
Must be mininum of 215 lm
Roughly the same size, but can be smaller or a little larger.
4.5 x .875 roughly with tape measure.
I currently run the textured bezal.
Thanks guys!
