Sold/Expired Sell:custom Quad XP-G P60 module 3rd Run *open*

:welcome: I sell this!



The 3rd run will be limited to Direct Drive 4200mA 3-mode XP-G R5 only! The sale number is ten in all.



The module sends it out from the middle of January, 2011.



I begin to sell it for $160(Direct Drive) $180(4200mA 3-mode) including the EMS postage!



The GITD processing is plus $10.



This becomes very hot.

The use battery is with 3.7V Li-Io battery protection circuit.

If a light becomes hot, please cut the light which is in a dangerous state.

Please be careful to the handling.

After understanding, please refer as things mentioned above.



?This light creates excessive heat

?The consecutive lighting is dangerous.

?If a light is overheated, please turn off the light.

?This light may cause eye damage

?This light will burn the skin at close range.

?This light may cause combustibles to ignite

?This drop-in is a direct drive unit.

?IMR cells are not recommended.



When you used the large-capacity battery except 17670 and 18650 of the battery with the protection circuit, the possibility that an excessive electric current flows, and LED is broken is very high.

Because I sell 4200mA converter in 2nd Run if you use a large-capacity battery except 17670 and 18650, please wait till then.

Please use only 17670 or 18650.

It is very likely that LED is broken!





:thumbsup:

I sell this custom Quad XP-G P60 module.

I begin to sell it for $160(DD) $180(4200mA 3-mode) including the EMS postage!

This light creates excessive heat.

Please use 18650 or 17670 expensive battery of the electric discharge performance.

The payment is PeyPal.

Post your order here and I will PM you the total along with my PayPal address.





Cutter-XPG25RDR5-CW (remodeling board 20mm)





Carclo 24mm Quad Optics







Quad XP-G DD Module



Quad XP-G Module 4200mA 3-mode

*3 modes: Low-Med-High

* Voltage input: 2.8V - 5.5V

* The memory feature will memorize the last mode





surefire 6P C2 normal body

:welcome: I sell this!



The 3rd run will be limited to Direct Drive 4200mA 3-mode XP-G R5 only! The sale number is ten in all.



The module sends it out from the middle of January, 2011.



I begin to sell it for $160(Direct Drive) $180(4200mA 3-mode) including the EMS postage!



The GITD processing is plus $10.



This becomes very hot.

The use battery is with 3.7V Li-Io battery protection circuit.

If a light becomes hot, please cut the light which is in a dangerous state.

Please be careful to the handling.

After understanding, please refer as things mentioned above.



?This light creates excessive heat

?The consecutive lighting is dangerous.

?If a light is overheated, please turn off the light.

?This light may cause eye damage

?This light will burn the skin at close range.

?This light may cause combustibles to ignite

?This drop-in is a direct drive unit.

?IMR cells are not recommended.



When you used the large-capacity battery except 17670 and 18650 of the battery with the protection circuit, the possibility that an excessive electric current flows, and LED is broken is very high.

Because I sell 4200mA converter in 2nd Run if you use a large-capacity battery except 17670 and 18650, please wait till then.

Please use only 17670 or 18650.

It is very likely that LED is broken!





:thumbsup:

I sell this custom Quad XP-G P60 module.

I begin to sell it for $160(DD) $180(4200mA 3-mode) including the EMS postage!

This light creates excessive heat.

Please use 18650 or 17670 expensive battery of the electric discharge performance.

The payment is PeyPal.

Post your order here and I will PM you the total along with my PayPal address.





Cutter-XPG25RDR5-CW (remodeling board 20mm)





Carclo 24mm Quad Optics







Quad XP-G DD Module



Quad XP-G Module 4200mA 3-mode

*3 modes: Low-Med-High

* Voltage input: 2.8V - 5.5V

* The memory feature will memorize the last mode





surefire 6P C2 normal body

Keshi,

I found your "open" thread selling the triple XP-G for the Solarforce L2P. However while I found it doing a search I the site does not allow for threads that have been added to. So I decided to try to contact you using this thread in hopes that I can purchase the module drop in that I want.
So, if the administrators allow my first post to go through in the thread that I found doing a search you may see this same request from me. The part I want to buy is listed here below. I don't know if the part includes heat sink and Carcla lens. I wish to buy the part in any event. My email is [email protected] Please contact me there. I can make Paypal payment if you can sell me the part. Also feel free to let me know if the cost is higher now.
Thank you
Jim


4) tliple XP-G R5 3-mode 2800mA $135 Mat black G.I.T.D A part of the PCB In stock : 1

Only as a hint the latest thead was this one:

http://www.candlepowerforums.com/vb...d-XP-G-5.6A-3-mode-P60-module-7th-Run-*close*