QUESTION FOR THOSE WITH JETBEAM RRT3 (WITH HANDLE)

Hi everyone. This is a question for anyone who has a Jetbeam Raptor 3 with the carry handle. Or anyone else in the know. I was wondering if I could buy the carry handle and put it on my Olight SR90?



The body of the SR90 is 50mm in diameter (as measured by myself with calipers). I get some conflicting body diameters of the Jetbeam RRT3. One site says 46mm diameter and another one says 48mm diameter. What I want to know is this. How does the carry handle slot into the Jetbeam? Is it a fixed sized ring that fits snugly into the body? Or is it a cut ring that expands and then you screw in tight until it presses firmly into the body? If the latter is the case, is it possible that it could expand enough to fit the SR90 body?



I think the carry handle is a better way of carrying around the SR90 and would dearly love to buy the Jetbeam handle and clamp this onto it.



Thank you.

The body is 46mm
Here is the clamp and handle kit.http://www.lightjunction.com/jetbeam-flashlights/jetbeam-accessories/RM46MCH46.html?zenid=c5932fa7fc03d3392e5e7ede6690ba59

It uses a set screw to lock into place on the RRT-3. The two knobs/screws you see are for tighten the handle in place.